Part #/ Keyword
All Products

DIY a RIDEN DPS5020 Power Supply

2026-11-18 15:00:48Mr.Ming
twitter photos
twitter photos
twitter photos
DIY a RIDEN DPS5020 Power Supply

If you happen to have a RIDEN DPS5020 programmable power supply but lack a suitable high-power pre-stage power supply to power it, you can consider using a transformer from an old UPS. You can open the UPS, remove its internal transformer, and try using it to power the RIDEN DPS5020.

image.png

The transformer is relatively large and heavy. Its high-voltage side has four wires: red, brown, yellow, and black. Its low-voltage side has three wires: blue, brown, and red. When you connect 220V AC to the red and black wires on the high-voltage side, the voltage between the two gray wires on the high-voltage side is 30V AC. The voltage between the blue and brown wires on the low-voltage side is also 30V AC, and the no-load power consumption is 16W.

image.png

When you connect 220V AC to the brown and black wires on the high-voltage side, the voltage between the blue and brown wires on the low-voltage side is 35V AC, and the no-load power consumption is 21W.

image.png

image.png

When you connect 220V AC to the yellow and black wires on the high-voltage side, the voltage between the blue and brown wires on the low-voltage side is 40V AC, and the no-load power consumption is 30W. At this point, the transformer produces a noticeable humming noise.

image.png

image.png

As you can see, when you use the yellow and black wire combination, the low-voltage side outputs 40V AC, which produces approximately 56V DC after rectification and filtering. This meets the input requirements of the RIDEN DPS5020, although the main drawback is the increased noise. Since you do not frequently need to operate at high voltages during everyday use, you can add a switch to select whether the 220V AC input connects to the red or yellow wire. When you need a lower input voltage, you can switch to the red-wire circuit. This reduces transformer noise and lowers no-load power consumption.

image.png

When you use the red and black wires, the DC input voltage to the RIDEN DPS5020 is 41V.

image.png

When you use the yellow and black wires, the DC input voltage to the RIDEN DPS5020 is 55V.

The rectifier uses a GBJ2510 bridge rectifier rated at 25A/1000V.

image.png

The filtering section uses two 63V/4700μF electrolytic capacitors.

image.png

All components are assembled and housed inside the original UPS enclosure.

image.png

image.png

image.png

image.png

Safety Note: Please take appropriate precautions when working with 220V AC power. Ensure that all connections are properly insulated and that the transformer is securely installed in a suitable enclosure. Check the wiring carefully before powering on the equipment to ensure safe and reliable operation.


* Solemnly declare: The copyright of this article belongs to the original author. The reprinted article is only for the purpose of disseminating more information. If the author's information is marked incorrectly, please contact us to modify or delete it as soon as possible. Thank you for your attention!