Part #/ Keyword
All Products

DIY LED Tester Probe Adapter for 3V and 6V LED Chips

2026-11-20 14:23:55Mr.Ming
twitter photos
twitter photos
twitter photos
DIY LED Tester Probe Adapter for 3V and 6V LED Chips

If you want to test several LED boards, you may find that the diode mode on your multimeter can only test 3V LED chips. Even when they light up, their brightness is very weak.

image.png

A 6V 1W LED cannot light up at all in this mode. So, you decide to make a custom probe adapter specifically for testing LED chips.

image.png

Luckily, you have an unused USB charging cable.

image.png

However, its built-in connector is too small, measuring only 2 mm.

image.png

Prepare a 5.8 mm male spade terminal.

image.png

Widen the opening on one side of the terminal slightly.

image.png

Make sure the opening is large enough for the connector to fit snugly without coming loose easily.

image.png

Next, select a single 0.8 mm diameter wire core from a high-quality Ethernet cable.

image.png

Strip off the outer insulation and cut the wire to a length that matches the connector.

image.png

Use wire crimping pliers to crimp one wire and the Ethernet cable core together as shown, then slide a silicone sleeve over the connection.

image.png

Once this step is complete, you can insert the USB charging cable's power connector into the terminal.

image.png

Next, take another spade terminal of the same type and gently pry open the spring tabs on both sides.

image.png

Find a round rod with a diameter of 4 mm. A screwdriver shaft will also work. Use pliers to bend the terminal into a round sleeve shape.

image.png

You do not need to make the dimensions perfectly precise. Just make sure that the multimeter probe can fit into the sleeve easily.

image.png

Crimp the finished round sleeve terminal onto the negative wire.

image.png

Make another one using the same method and crimp it onto the positive wire.

image.png

Connect an adjustable resistor between the two wires to regulate the current and adjust the voltage.

image.png

The main structure is now complete.

image.png

Connect a pair of multimeter probes.

image.png

Then, use a mobile phone charger as the power source.

image.png

The measured supply voltage is 4.93V. The voltage drop is caused by the relatively long wires.

image.png

When you use this adapter to test a 6V LED, the LED lights up just right. Its brightness is moderate and not too dazzling.

image.png

You can also test 3V LEDs, and their illumination is much better than when using the multimeter's diode mode. If the light is too bright, you can simply turn it down.

image.png

After completing this modification, you will find it much more convenient to use.


* Solemnly declare: The copyright of this article belongs to the original author. The reprinted article is only for the purpose of disseminating more information. If the author's information is marked incorrectly, please contact us to modify or delete it as soon as possible. Thank you for your attention!